Loading ...
Loading ...
Loading ...
Installation instructions en
13
¡ If the exhaust air is conveyed through the external
wall, a telescopic duct should be used.
12.10 Information about circulating-air
mode
The appliance must only be operated when it is se-
curely installed and the pipework is connected.
12.11 Installation
Checking the wall
1.
Check whether the wall is vertical and has sufficient
load-bearing capacity.
The maximum weight of the appliance is 16kg.
2.
Drill the hole depth in accordance with the length of
the screws.
The wall plugs must have a secure grip.
The enclosed screws and wall plugs are suitable for
use with solid brickwork. Suitable fasteners must be
used for other structures (e.g. plasterboard, aerated
concrete, Poroton blocks).
Note:When drilling holes, always check the wall's sta-
bility before the unit is attached to the wall. If the wall is
not sufficient stability, the appliance cannot be moun-
ted.
Preparing the wall
1.
Ensure that there are no electrical wires, gas pipes
or water pipes in the area where holes are to be
drilled.
2.
Cover the hob to prevent damage.
3.
Mark a vertical centre line on the wall from the ceil-
ing to the lower edge of the appliance.
4.
Centre the angle brackets using the centre line.
The centre of the angle brackets is marked with a
notch.
5.
Align the angle brackets horizontally.
6.
Mark the holes for the angle brackets in the flue.
7.
Mark the holes for the appliance bracket.
370
8.
Drill the holes.
9.
Insert the wall plugs flush with the wall.
10.
Screw on the angle bracket for the flue duct.
11.
Screw in the screws for the appliance bracket
loosely; do not tighten them fully.
Preparing the appliance
▶
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
Installing the appliance
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
1.
Remove the protective film from the rear.
‒ Once the appliance is installed, fully remove the
protective film.
Loading ...
Loading ...
Loading ...