Loading ...
Loading ...
Loading ...
RSL-382S/2702S
8. Carefully pull up the laminate from the
lower roll up towards the first idle bar and
then around the back side of the second
Idler (Caution: lower roller may be hot).
(Picture 3)
9. Tack the lower film to the upper film that
is resting on the main roller (Picture 4).
10. Reinstall the Front Table and close the
Safety Cover.
11. Adjust the nip setting to 1/4'' (6mm).
12. Insert and push the leader boards on
each end until boards reach the front nip
point.
13. Adjust the nip setting to "Laminating"
mode.
14. Push the Run button.
15. Push the leader boards between the pair
of main rollers (Picture 5).
16. Press the Run button and adjust the
supply roll tension knobs by rotating
clockwise or counterclockwise. Turn it
until the supply roll films have some
resistance (the tension varies depending
on the film thickness; the
thicker the film the more tension is
required) (Picture 6).
17. Press Stop button when the leader board
has completely exited the rear of the unit.
18. Use the Cross Cutter to cut the leader
board from the web (see page 18).
19. Peel Trim any excess film off of the
leader board edges. The leader board
can be reused.
20. S e t t h e r o l l e r n i p s e t t i n g t o t h e
appropriate position for the lamination or
encapsulation application.
7
Picture 3
Picture 4
Picture 5
Picture 6
Loading ...
Loading ...
Loading ...