Loading ...
Loading ...
Loading ...
Warnings
Overheating
protection
The hob is equipped with overheating protection to
protect the electronics. This switches all the burners
off in the event of overheating and the “power on/off”
indicators in all the burners and the main switch
flash.
Turn all control knobs to the 0 position. Wait until the
appliance has cooled down sufficiently and the power
on/off indicator for the main switch has gone out.
Now you can switch on the appliance as usual.
The burner power on/off indicators stop flashing
Childproof locks
9
rapidly or switch over to the residual heat indicator.
To deactivate the childproof lock, press on the child
lock for a few seconds until the main switch indicator
comes on. The hob can then be switched on as
usual.
by means of the main switch, then press on the child
lock for a few seconds until the child lock indicator
comes on. The hob cannot then be switched on.
To activate the childproof lock, disconnect the hob
is interrupted.
to the mains electricity or if the electricity supply
This apparatus will not function if it is not connected
It is normal to hear a slight whistling noise while the
burner is operating.
When it is first used, it is normal for the burner to give off
odours; this does not pose any risk and does not indicate
a malfunction; they will disappear in time.
A few seconds after the burner is switched off, a sound
(thud) will be produced. This is not a fault - this means
that the safety device is no longer operating.
Keep the burner as clean as possible. If the ignition
sparkers are dirty they will not light properly. Clean them
periodically using a small non-wire brush. Bear in mind
that the ignition sparkers must not suffer any serious
impacts.
An orange-coloured flame is normal. This is caused by
the presence of dust in the atmosphere, spilt liquids, etc.
If the burner flames are accidentally blown out, switch off
the burner operating control knob and do not try to relight
it for at least one minute.
Loading ...
Loading ...
Loading ...