Loading ...
Loading ...
Loading ...
Setting Surface Controls (cont'd)
To Set the Cooktop Lockout Feature _COOKTOP
The _ pad is used to activate the Cooktop Lockout feature which wii[ lock ai[ surface elements from being accidentally
turned ON, This feature wili only lock the cooktop,
mNSTRUCTmONS
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold _ until "CLO" appears. Continue holding until a
second beep sounds (after 3 seconds), if a triple beep sounds instead,
check ail surface elements and turn them to the OFF position and repeat
this step. I_ wiil appear in the display indicating the cooktop controls and
functions are locked out until the cooktop is unlocked (See Figure 1).
3. To remove "CLO" from the display, press _ or wait 30 seconds _)
(See Figure 2).
PRESS DISPLAY
To turn the Cooktop Lockout Feature OFF:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold _ until "CLO" appears. Continue holding until a
second beep sounds (after 3 seconds), if a triple beep sounds
instead, check all surface elements and turn them to the OFF
position and repeat this step. 1_1will disappear from the display
indicating the cooktop may be used normally (See Figure 3).
3. To remove "CLO" from the display, press @ or wait 30 seconds
(See Figure 4).
Figure 1
Figure 2
Figure 3
Figure 4
Note: Starting a Self-Clean cycle wili automatically turn ON the Cooktop Lockout feature, The cooktop wili remain
locked until the Self-Clean cycle has completed and the oven door has unlocked, if a power failure occurs after the
Cooktop Lockout has been activated, you must turn OFF the Cooktop Lockout feature before being able to use the
cooktop features again,
ΒΈ:121111
How the Electronic Surface Element Controls work when the Sabbath feature is ON.
When your Oven Sabbath feature is ON, the Electronic Surface Elements are also in Sabbath mode. This means that all
electronic surface element control displays show "Sb". The surface elements can be used even if the Sabbath Feature is
on,
To turn ON a Surface Element when the Oven Sabbath Feature is active:
if you turn on a surface element when the even Sabbath feature is on, the electronic surface element control wii[ record
that request and execute it with a 15-30 seconds delay, So the element wii[ start heating 15-30 seconds after the surface
element control was turned on, As the oven control the surface element display wii[ not show the setting because "Sb" is
on in the displays, When necessary, it is possible to adjust the power of the surface element but you have to remember
that the surface element control wii[ adjust the temperature with the same delay,
To turn OFF the Surface Element when the Oven Sabbath Mode is active:
To shut off the surface element while the Sabbath feature is ON, proceed as usual but take note that the element wii[
immediately turn off without any delay,
Note: Refer to page 33-34 to activate the Sabbath Feature.
13
Loading ...
Loading ...
Loading ...