Loading ...
Loading ...
Loading ...
6. Removekeyfrom bag and start the
engine (see "TOSTARTENGINE"in
the Operationsectionof this manual).
After engine has started, move throttle
control to idle position.
7. Depress clutch/brake pedal into full
"BRAKE" position and hold. Move
gearshift lever to 1st gear.
8. Slowly release clutch/brake pedal and
slowly drive tractor off skid.
9. Apply brake to stop tractor, set park-
ing brake and place gearshift lever in
neutral position.
10. Turn ignition key to "STOP" position.
Continue with the instructions that follow.
ASSEMBLE FRONT WHEEL TO
MOWER
1. Using shoulder bolt, washer and
Iocknut from parts bag, assemble front
wheel to mower as shown. Tighten
securely.
3. Remove plastic tie securing belt, bring
belt forward and check belt for proper
routing in all mower pulley grooves.
NOTE: Be sure mower side suspension
arms (A) are pointing forward before slid-
ing mower under tractor.
4. Slide mower under tractor until it is
centered under tractor.
5. FIRST INSTALL ANTI-SWAY BAR (S).
From right side of mower, insert ant-
sway bar into hole in transmission
bracket (T).
INSTALL MOWER AND DRIVE
BELT
See MOWER AND DRIVE BELT AS-
SEMBLY Supplement Sheet for additional
guidance on this assembly.
Be sure tractor is on level surface and
engage parking brake.
1. Lower attachment lift lever to it's lowest
position.
A CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
2. Turn steering wheel to the left as far as
it will go and position mower on right
side of tractor with deflector shield to
the right.
Pivot bar towards you and insert
other end of bar into hole in rear
mower bracket (D). Move mower as
needed to insert bar.
Secure with washer and retainer
spring as shown.
9
Loading ...
Loading ...
Loading ...