Loading ...
Loading ...
Loading ...
23
English
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
13
Compressor cylinder finish wornContact a DEWALT factory service center or a D
E
WALT authorized
service center.
14
Regulator is not adjusted correctly for accessory
being used.
It is normal for some pressure drop to occur when and acces-
sory is used, adjust the regulator as instructed in Regulator under
Features if pressure drop is excessive.
NOTE: Adjust the regulated pressure under flow conditions while
the accessory is being used.
15
Damaged regulatorReplace
16
Regulator openRoate the regulator knob counter-clockwise to its built-in stop.
17
Low voltage/motor overloadCheck that power supply is adequate and that compressor is
on a dedicated circuit. If using extension cord, try using without.
If compressor is connected to a circut protected by a fuse, use
dual element time delay fuses (Buss Fusetron type âTâ only).
18
Restricted air passagesInspect and replace transfer tubes or check valve, as required.
19
Low voltage motorFurnish adequate powder.
20
Bad check valveReplace check valve.
21
Seized pumpContact a D
E
WALT factory service center or a D
E
WALT authorized
service center.
22
Poor ventilationRelocate compressor to an area with cool, dry, well circulated
air, at least 12 in. from nearest wall.
23
Dirty cooling surfacesClean all cooling surfaces thoroughly.
24
Too much back pressure in tank.Open drain valve when starting motor.
25
Compressor too coldMove compressor to a warmer location.
Loading ...
Loading ...
Loading ...