Loading ...
Loading ...
Loading ...
ASSEMBLY
TO ASSEMBLY BAGGER (See Figs 6 = 8)
•Unfold bag and stand right side up.
• Feed front bagger frame (1) up through fabric loops at
each side of bagger.
• Snap bottom of front bagger frame (1) into snap feature
at front of bagger bottom.
• Slide bagger fabric loop (2) segments at the ends of
bag onto top bagger frame tubing.
• Uninstall two (1\4"-20 x 1.15") hex bolts (3) from the
front of top frame.
• Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through
holes at top of the front bagger frame and thread into
nuts inside the tubing of top bagger frame.
•Remove clevis pin (6) and retainer spring (7) from
bagger handle (8).
•Slide bagger handle (8) down through bagger cover
and frame upper weldment holes.
•Reinstall clevis pin (6) through hole at bottom of bag-
ger handle and slide retainer spring (7) into hole at
the end of the clevis pin until it locks into place
Fig. 8
TO ADJUST BAGGER FULL LEVER/PADDLE
(See Fig 9)
• Before adjusting, tractor engine must be shut off and
parking brake engaged.
Fig. 6
•Uninstall (1/4"-20) lock nuts (4) at bottom offront bagger
frame.
•Unfold cross braces (5) and attach to carriage bolts at
bottom corners of front bagger frame.
•Reinstall (1/4"-20) lock nuts (4) and tighten until fully
seated.
Fig. 9
•For the heaviest/wet grasses, remove paddle (3).
•For lighter grasses use the paddle (3) on setting "1",
"2", or "3" ("3" being for the lightest or dry grass).
•Choose your setting and rotate the bagger paddle (3)
so that the desired number (setting) faces you.
•Setting may be changed by loosening fasteners (4 and
5), removing/rotating paddle (3), and tightening again.
Fig. 7
8
Loading ...
Loading ...
Loading ...