Tripp Lite B160-200-HSI Owner's Manual

Owner's Manual - Page 14

For B160-200-HSI. Also, The document are for others Tripp Lite models: B160-101-DPSI, B160-101-DPHDSI, B160-101-HDSI, B160-103-HDSI, B160-201-HSI, B160-202-HDSI, B160-301-HDSI, B160-001-CSI, B160-001-DPSI, B160-001-HDSI, B160-001-VSI, B160-100-CSI, B160-100-DPSI, B160-100-HDSI, B160-100-VSI

Loading ...

Do not connect the external power supply to the transmitter at

this time. The transmitter should not be powered on until all

audio/video equipment is connected and powered on.

8. To connect additional transmitter(s), repeat steps 2 through 7.

9. Connect a monitor to the receiver unit’s audio/video Output port

(See Optional Accessories for available Tripp Lite audio/video cables).

10. (Optional) Connect the serial device’s DB9 port to the receiver unit’s

serial port. Depending on the model, the serial port will be either DB9 or

3.5 mm. Models with 3.5 mm jacks include a 3.5 mm to DB9 adapter.

Models with DB9 ports require standard RS-232 DB9 cable (sold

separately) for connecting a device.

11. (Optional) Connect the included IR-IN cable to the receiver unit’s IR-IN

port. Place the sensor on the IR-IN cable in an unobstructed area within

clear view of the remote control.

Note: The IR-IN cable accepts a signal from a remote control and sends it to a

device being controlled on the other end of the installation.

12. Set the Channel Number (0 to 63 are available) on the front of the

receiver to a desired number by pressing the Up / Down buttons. This

number MUST be the same on all transmitter and receiver units in the

installation. If you are using transmitter and receiver units that are all

brand new, they will default to channel number 0, and you can leave the

channel unchanged upon installation.

Note: A locking mechanism prevents the Channel Number from being

unintentionally changed. When the Channel Number is locked, hold down the Up

and Down buttons until the Channel Number starts blinking. Then navigate to the

desired Channel using the Up / Down buttons. Once the desired Channel Number

has been selected, lock the Channel Number by holding down the Up and Down

buttons until the Channel Number stops blinking.

13. Connect the RJ45 Input port on the receiver unit to an RJ45 port on the

network switch using Cat5e/6 cable.

Note: The maximum allowable cable length from receiver to switch is 328 ft. (100 m).

Point-to-Multipoint Installation –

Managed Switch with IGMP

Loading ...

Tripp Lite B160-200-HSI 2-Port HDMI over IP Extender Receiver over Cat5/Cat6, RS-232 Serial and IR Control, 1080p 60 Hz, 328 ft. 100 m, TAA

Owner's Manual - Page 14