Loading ...
Loading ...
Loading ...
7
Installing Batteries in the Remote Control
1.
Slide the back cover to open the battery compartment of the remote
control.
2.
Insert two AA or AAA size batteries. Make sure to match the (+)
and ( - ) ends of the batteries with the (+) and ( - ) ends indicated
in the battery compartment.
3.
Close the battery compartment with the cover.
NOTE
Product image is only for reference, actual product may vary in appearance.
Dispose of your batteries in a designated disposal area.
Do not mix battery types or combine used batteries with new ones.
Remove depleted batteries immediately to prevent battery acid from leaking into the
battery compartment.
If you do not intend to use the remote control for a long time, remove the batteries.
Leaving a battery in an extremely high temperature surrounding environment that
can result in an explosion or the leakage of flammable liquid or gas.
Battery chemicals can cause a rash. If the batteries leak, clean the battery
compartment with a cloth. If chemicals touch your skin, wash immediately.
Risk of fire or explosion if the battery is replaced by an incorrect type.
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a
battery, that can result in an explosion.
A battery subjected to extremely low air pressure that may result in an explosion or
the leakage of flammable liquid or gas.
Remote Control Operation Range
Disposal of this unit
Product should not be damaged, dismantled or thrown in municipal waste.
It should be packed and handed over to authorised re-cycler.
1. The remote control can work at a distance of up to 8
meters in
front of the TV set.
2. The remote control angle: taking the remote sensor as
an apex, 6 meters away, its controlled horizontal angle is
within ±30°, while the vertical angle is within ±15°.
3. The operating distance may vary depending on the
brightness of the room.
6m
8m
6m
6m
8m
6m
30° 30°
15°
15°
Pairing the Remote Control (only for Bluetooth remote control)
Pair the remote to the TV after you power it on. Keep the remote control within 3
metres from the TV. Press any button (except power and mic button) to pair.
NOTE
In special cases, press and hold [ ] button to pair.
If an unknown error occurred with the remote, then it could have been caused by
interference. Try to remove what's causing the interference and pair it again.
If an unknown error occurred in the remote control while the battery power is
normal, you can take out the batteries, press any key for 1~2 seconds, and insert
them back. Then the remote control will work normally.
The remote cannot be paired to the TV while the TV is in standby mode.
Loading ...
Loading ...
Loading ...