Loading ...
Loading ...
Loading ...
CARE AND CLEANING
(continued)
Coil Surface Unit Module
Clean the area surrounding the surface units
according to either the Brushed Chrome or Porcelain
section (depending on your modeb.
To clean the surface units, turn the control to the
highest setting for a minute. The coils will bnrn off
any soil.
CAUTION
° Be sure all controls are turned to OFF and
surface units are cool be%re attempting to
remove them.
, Do not immerse the surface units or the module
in liquids of any kind.
, Do not clean the snrface nnits or the module in
a dishwasher.
, Do not bend the snr_i_ce unit plug terminals.
, Do not attempt to clean, adjust or in any way repair
the plug-in receptacle.
To remove a surface unit:
Surface Unit
To remove the drip pans
£br cleaning, the sur£i_ce DripPan
units must be removed J
first.
iF-
Lift the surti_ce unit about
1 inch above the drip pan //
and pull it ont.
Do not lift the surface
unit more than 1 inch.
If you do, it may not lie
llat on the drip pan when
you plug it back in.
Repeated lifting of the surface unit more than
1 inch above the drip pan can permanently
damage the receptacle.
To replace a surface unit:
, Replace the drip pan into the recess in the cooktop.
Make sure the opening in the pan lines up with the
receptacle.
, Insert the terminals of the suriace unit through the
opening in the drip pan and into the receptacle.
, Gnide the snr_ce nnit into place so it rests evenly.
Drip Pans
Remove the snr_i_ce nnits. Then lift out the drip pans.
For best results, clean the drip pans by hand.
Place them in a covered container (or a plastic bag)
with 1/4 cup ammonia to loosen the soil. Then scrub
with a soap-filled scouring pad if necessary. Rinse
with clean water and polish with a clean, soft cloth.
The drip pans may also be cleaned in the dishwasher.
Do not cover the drip pans with %iL
Using _bil so close to the receptacle conld cause
shock, fire or damage to the cooktop.
Clean the area under the drip pans often.
Bnilt-np soil, especially grease, may catch on fire.
Cleaning the Radiant Module
Normal Daily Use Cleaning
ONLY use the recommended cleaning
cream, Cerama BryteL on the glass
surface. Other creams may not be
as efl'ective.
To maintain and protect the surt;ace of
your radiant module, tbllow these steps:
1. Betbre using the radiant module
for the first time, clean it with the
cooktop cleaning cream. This helps
protect the top and makes clean-up
easier.
Clean your
radiant module
after each spill.
2. Daily use of the cooktop cleaning cream will help
keep the glass surface looking new.
3. Shake the cleaning cream well. Apply a few drops of
the cream directly to the glass surface.
4. Use a paper towel or sponge to clean the entire
surface.
NOTE: It is very important that you DO NOT
heat the radiant module until it has been cleaned
thoroughly.
26
Loading ...
Loading ...
Loading ...