Loading ...
Loading ...
Loading ...
English 7
1 Driver hub
2 Screw M6x16, washer
8. Position the driver hub with the feather key and push it in.
9. Fasten the driver hub with the screw and washer.
Note
Check that the feather key is fitted correctly.
10.Fit the side brush and fasten it with the M6x16 screw (3x).
1 Cable with cable grommet
2 Bracket
11.Push the cable grommet onto the cable.
12.Thread the cable into the bracket, guide it through the pipe
and route it properly to the electronics compartment.
1 Cable with cable grommet
2 Bracket
Repeat the entire procedure at the other side.
Installing the lifting motor
1. Remove the floor plate.
1 Guide pulley
2 Retaining plate
3 Holder
2. Fasten the retaining plate and the pulley to the holder with the
M8x45 screw and self-locking nut.
1 Holder
2 Retaining plate
3 Lifting motor
3. Fasten the lifting motor to the holder with the M8x45 screw and
nut.
4. Fit the retaining plate onto the end of the screw and fasten it
with the self-locking nut.
The retaining plate serves as a support for the lifting motor
(view from below).
Loading ...
Loading ...
Loading ...