Loading ...
Loading ...
Loading ...
SONANCE
|
PROFESSIONAL SERIES SURFACE MOUNT
|
INSTALLATION MANUAL 6
9. Determine the proper wattage
setting for each speaker in
the installation and set each
speaker’s transformer tap
selector (see figure 15).
8. Strip approximately .1875”
(5mm) of the insulation off
each wire. Insert the wire into
the correct square opening on
the connector. Use a small flat
head screwdriver to tighten
the corresponding screw to
secure the wire (see figure 12).
When using multiple speakers you can connect the speakers either
in parallel or in the loop through method as shown (see figure 13 & 14).
Pin 1 + Positive In
Pin 2 - Negative In
Pin 3 + Positive Out
Pin 4 - Negative Out
INSTALLING THE SPEAKERS
6. Slide the speakers onto the brackets until the locks snap into place
(see figure10).
• Pull enough wire through the front of the speaker to allow
connection to the terminals.
10. Fit the wiring terminal covers into the recesses in the speakers’
front panels (see figure 16).
• The covers should fit tightly, but can be removed and replaced
if the speakers need to be disconnected.
11. Fit the grilles onto the speakers (see figure 17).
Parallel Connection To Next SpeakerFrom Power Amplifier
Loop Thru Connection To Next SpeakerFrom Power Amplifier
Parallel Connection To Next SpeakerFrom Power Amplifier
Loop Thru Connection To Next SpeakerFrom Power Amplifier
7. Connect the wires from your
amplifier to the input connector
(see figure 11).
+
_
IN OUT
+
_
From Power Amplifier
Parallel Connection
To Next Speaker
From Power Amplifier
Loop Through Connection
To Next Speaker
FIGURE 10:
ATTACH SPEAKERS TO BRACKETS
FIGURE 11:
INPUT CONNECTOR
FIGURE 13: PARALLEL CONNECTION
FIGURE 14: LOOP THRU CONNECTION
FIGURE 15:
TRANSFORMER TAP SELECTOR
FIGURE 16:
ATTACH THE
CONNECTOR COVER
FIGURE 17:
ATTACH THE GRILLE
FIGURE 12:
SECURING THE WIRE
Loading ...
Loading ...
Loading ...