Loading ...
Loading ...
OPERATION
Before using your jack:
1. Turn release valve counter-clockwise to open. Pump jack handle
about 6 full strokes to assure complete distribution of hydraulic fluid.
(See Figure 1)
To raise:
Place pump handle over release valve
and turn clockwise to close. Make
certain that load is on center of saddle. Insert handle into handle
sleeve and pump to raise load to desired height. Transfer load to
jack stands or other appropriate supports before working under
load. (See figure 2)
To lower:
Raise load enough to remove
jack stands. Slowly turn
release valve counter-
clockwise just enough to
allow controlled descent.
(Never turn counter-clockwise more than 3 full turns)
1. When jack is not in use, lifting arm and handle sleeve should be in
fully down position to keep their machined surfaces free from
corrosion.
2. Keep jack clean and well lubricated at points illustrated in figure 3.
3. For best results, use only hydraulic fluid with a rating of SAE 10 for
refills. Check fluid level with jack in fully down position. Fluid level
should be up to bottom of oil fill plug. (See figure 5)
4. Regularly check for loose, worn or
damaged parts and repair or replace
as necessary.
5. Replace worn or damaged parts
with Performance Tool replacement
parts. Be sure that only qualified
personnel perform repairs.
CARE & MAINTENANCE
1
2
3
4
Figure 3
Figure 2
Figure 1
Loading ...
Loading ...
Loading ...