Loading ...
Loading ...
Loading ...
!
4
5
MANUAL
A INSTALLING THE HEATER
1
Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
a manual fuel pump
a transportation cap
these directions for use
Keeptheboxandthepackagingmaterials(Fig.A)forstorageand/or
transportation.
2
Open the lid of the removable tank and remove the piece of cardboard.
3
Fill the removable tank as indicated in Section B.
4
The floor should be firm and completely level. Reposition the heater, when it
is not level. Do not try to correct the situation by placing books or other
goods under the heater.
5
Insert the plug intothewall-socket(230Volts-AC/50Hz)andsetthe
correct time using the adjustment keys
(refer to Section C).
6
Your heater is now ready for use.
SET ALTITUDE
1
If the heater is used at a height of 800 m to 1300 m, use the altitude mode 1.
Push the altitude button with thin rod like a clip and plug into the outlet
simultaneously. Then “1
” will be shown on the display.
2
If the heater is used at a height of 1300 m to 1900 m, use the altitude mode
2. After setting the altitude mode 1, push the altitude button with thin rod
and plug into the outlet simultaneouosly again. Then “2
” will be shown on
the display.
3
Switch off the altitude mode by pressing the altitude button and into the
outlet simultaneously after setting altitude mode 2. Then “0” will be shown
on the display and “
” will be disappeared.
NOTE: When the altitude mode 1 is set, the altitude mark “ ” is lit on the display.
When the altitude mode 2 is set, the altitude mark “
” is blinking during
operation.
NOTE: In the event of power failure or disconnection of heater, the altitude setting
will remain.
Do not use the heater at a height of over 1900 meters.
SWITCH THE VOLUME
This heater can be switched the buzzer sound volume. The initial setting is in
High level.
1
Push the SAVE key and holding it down for more than 3 seconds, then the
buzzer sound volume is switched from High to Low.
2
Push the SAVE key and holding it down for more than 3 seconds again,
then the buzzer sound volume is switched from Low to High.
NOTE:
The volume level is Low and High only, but the alarm by safety device
sounds in High level.
NOTE:
When the heater has been unplugged or after a power failure, the volume
will be the initial setting High.
B
A
Loading ...
Loading ...
Loading ...