Loading ...
Loading ...
3
Tools and Parts
Parts supplied
Removing the packaging
I CAUTION!
Remove carton carefully, wear gloves to protect against sharp
edges.
I WARNING!
Remove the protective lm covering the product before putting
into operation.
• Hood assembly with blower and LED lamps already installed.
• Hardware bag with:
Part Qty
Hood assembly
1
Rectangular duct 3⁄
4
” x 10” (8.3 x 25.4 cm)
1
4.5x13 mm
4
3.5x6.5 mm
1
Parts not supplied
Tools/Materials required
• Drill
• 1⁄
4
” (3.0 cm) drill bit
•
1
⁄
8
” (3.0 mm) drill bit for pilot holes
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Caulking gun and weatherproof caulking compound
• Saber or keyhole saw
• Metal snips
• Screwdrivers:
Phillips
Flat-blade
Parts needed
• Home power supply cable
• ½” (12.7 mm) UL listed or CSA approved strain relief
• 3 UL listed wire connectors
For vented installations, you will also need:
• 1 wall or roof cap
• Metal vent system
Optional Accessories
KIT # Part
30” (76.2 cm) 36” (91.4 cm)
Recirculating Kit KIT02178 KIT02179
7” Round Kit KIT02723
Upgrade
Filters Kit
KIT02591 KIT02592
Dimensions and
Clearances
E
A
B
C
F
D
Models
AUR330SSA AUR336SSA
A 30” (76.2 cm) 36” (91.4 cm)
B 20” (50.8 cm)
C 4
7
⁄
10
” (12 cm)
D 2
2
⁄
5
” (5.7 cm)
E 3
1
⁄
4
” x 10” (8.3 x 25.4 cm)
F 5⁄
10
” (13 cm)
Electrical Requirements
IMPORTANT
Observe all governing codes and ordinances.
It is the customer’s responsibility:
• To contact a qualied electrical installer.
• To assure that the electrical installation is adequate and
inconformance with National Electrical Code, ANSI/
NFPA 70— latest edition*, or CSA Standards C22.1-94,
CanadianElectrical Code, Part 1 and C22.2 No.0-M91 - latest
edition** and all local codes and ordinances.
• If codes permit and a separate ground wire is used, it is
recommended that a qualied electrician determine that the
ground path is adequate.
• Do not ground to a gas pipe.
Loading ...
Loading ...
Loading ...