Loading ...
Loading ...
Loading ...
6
5. Setup
Caution! Read All Instructions and Warnings Before Installation!
Warning: Charging stations can be extremely heavy. Do not attempt to unpack the charging station without assistance.
Follow the unpacking instructions document that shipped with this product before proceeding with setup. Use extreme caution
when handling the charging station and be sure to follow all handling and installation instructions. Do not attempt to install
equipment without first stabilizing the charging station.
5.1 Power Requirements
5.2 Installing the Handle Bracket, Corner Safety Bumpers and Power Cord Manager
The charging station must be plugged into an AC outlet with a dedicated
circuit. An AC outlet with a 20-amp (NEMA 5-20R) AC circuit is
recommended for powering the charging station. The AC outlet used to
power the charging station should not be shared. The total wattage of
the charging station and all connected components should not exceed
1800 watts. The AC power distribution unit is protected by a 15-amp
input breaker
A
.
To install the handle bracket, choose a side on which to install the bracket (the same side as the cable access hole grommet and power cord manager
is recommended). Using the included hex key tool and four (4) hex screws, secure the handle bracket to the charging station cabinet
A
. Then install
the two top corner safety bumpers using four (4) hex screws (two per bumper)
B
.
To install the cord manager, use two (2) hex screws to secure on
the same side as the cable access hole grommet
C
.
C
A B
A
Loading ...
Loading ...
Loading ...