Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
Before contacting the Service Centre, refer to the table below. Often the malfunctions are minor and can be solved in few minutes.
Malfunction
Possible cause
Solution
The tumble dryer does
not start.
The plug is not inserted into the socket.
Insert the plug into the socket.
The plug is faulty.
Try to plug another appliance in the same socket. Do
not use connecting electrical devices to the socket,
such as adapters or extensions.
A power failure occurred.
Wait for the power supply to be restored and switch
the fuse on again if necessary.
The door has not been closed properly.
Close the door.
The drying time has not been set correctly.
Refer to the "Drying Time" section to find the most
suitable drying time and options for the type of load.
The "Start" button was not pressed to begin drying. Press the "Start" button.
The drying times are
very long.
An appropriate maintenance was not carried out.
Refer to the "Care & Maintenance" section and
perform the described operations.
An incorrect drying time or option was selected for
the type of load.
Refer to the "Drying Time" section to find the most
suitable drying times cycle and options for the type
of load.
The garments are too wet.
Carry out a washing cycle with higher spin speed to
remove as much water as possible.
The dryer may be overloaded.
Refer to the "Drying Times" table to check the max
load for each drying times cycle.
The vent tube or air intake vent is clogged up.
Clean and do not occlude the vent tube and the air
intake vent, refer to "Care & Maintenance" section.
The dryer is noisy
during the first few
minutes of operation.
This is normal, especially if the dryer has not been
used for a long time.
If the noise persists during the entire drying cycle,
contact the After-sales Service.
Drum - slight odour or
vapour.
Slight odour or vapour may be found if you open
the door during its first use.
This is normal and should only last a few minutes.
The timer reset to zero
without the dryer
running.
This is normal, during this period you may hear a
ticking noise from the timer.
This ensures you select the correct drying time when
you next use the dryer.
09/2022
WARNING: unplug the dryer during the cleaning and
maintenance procedures.
Cleaning the tumble dryer
• The external metal, plastic and rubber parts can be cleaned with a damp cloth.
• At least every two or three months you MUST clean fluff build up around the filter housing and the vent tube. Check the vent
tube and any permanent venting fixture to make sure that there has been no accumulation of fluff or lint.
• Do not use solvents or abrasives.
CARE AND MAINTENANCE
Cleaning the door lter after each cycle.
Pull the filter out and clean it by removing the
lint from the filter surface under running water or
using a vacuum cleaner. For optimal performance,
dry up the filter before inserting it back in
place. Do not use the dryer without having
reinserted the lter in place.
Remove the door filter as described below:
1. Open the door and pull the filter upwards.
2. Remove the lint from all its parts. Replace the
filter correctly making sure it is fully seated.
The filter is an essential part for drying. It is
intended to collect the lint formed during the
drying process. If the lter is clogged, the air ow
inside the dryer can become seriously aected:
this will increase the drying time and energy
consumption, and could damage the dryer.
Power Consumption
Off-mode (Po) - Watts 0.00
Left-on mode (Pl) - Watts 0.00
Programmes Kg kWh Minutes
Standard Cotton*
4 2.95 101
Standard Cotton
2 1.40 51
Synthetics 2 0.84 35
*This is the reference setting used for the energy label and is
suitable for drying normal wet cotton laundry.
400011604041
TRANSPORT AND HANDLING
Never lift the dryer by holding on to its top side.
1. Unplug the dryer.
2. Make sure that the door is properly closed.
3. Disconnect the vent tube from the dryer.
THANK YOU FOR BUYING AN INDESIT PRODUCT.
In order to receive a more complete assistance, please
register your product on www.indesit.eu/register
Policies, standard documentation, ordering of spare parts and additional product information can be
found by:
• Visiting our website docs.indesit.eu and parts-selfservice.whirlpool.com
• Using QR Code
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product’s identifi cation plate.
EN
Quick guide
Before using the appliance carefully read the Safety
Instructions.
xxxxxxxxxxxx
xxxx