AEG FSK94858P 9000 ComfortLift Dishwasher 60cm Integrated Dishwasher

User Manual - Page 30

For FSK94858P.

PDF File Manual, 36 pages, Read Online | Download pdf file

FSK94858P photo
Loading ...
Loading ...
Loading ...
Problem and alarm code Possible cause and solution
The anti-flood device is on.
The display shows , Error i30
and Risk of flood detected.
Close the water tap and contact an Authorised Service Centre.
Malfunction of the water level detec‐
tion sensor.
The display shows i41 - i44.
Make sure that the filters are clean.
Switch the appliance off and on.
Malfunction of the wash pump or the
drain pump.
The display shows i51 - i59 or i5A -
i5F.
Switch the appliance off and on.
The temperature of the water inside
the appliance is too high or malfunc‐
tion of the temperature sensor oc‐
curred.
The display shows i61 or i69.
Make sure that the temperature of the inlet water does not exceed
60°C.
Switch the appliance off and on.
Technical malfunction of the appli‐
ance.
The display shows iC0 or iC3.
Switch the appliance off and on.
The level of water inside the appli‐
ance is too high.
The display shows iF1.
Switch the appliance off and on.
Make sure that the filters are clean.
Make sure that the outlet hose is installed at the right height above the
floor. Refer to the installation instructions.
Network unit error.
The display shows iC4 Network In‐
terface Error or iC5 Network Inter‐
face Error.
Contact an Authorised Service Centre.
The appliance stops and starts
more times during operation.
It is normal. It provides optimal cleaning results and energy savings.
The programme lasts too long.
If the delay start option is set, cancel the delay setting or wait for the
end of the countdown.
Activating options often increases the programme duration.
The displayed programme duration
is different than the duration in the
consumption values table.
The pressure and the temperature of the water, the variations of the
mains supply, the options, the quantity of dishes and the degree of soil
can change the programme duration.
The remaining time in the display in‐
creases and skips nearly to the end
of the programme duration.
This is not a defect. The appliance is working correctly.
Small leak from the appliance door.
The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
The appliance door is not centred on the tub. Adjust the rear foot (if ap‐
plicable).
The appliance door is difficult to
close.
The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
Parts of the tableware are protruding from the baskets.
30 ENGLISH
Loading ...
Loading ...
Loading ...