Loading ...
Loading ...
Loading ...
Washer Symptom Possible/Cause Solution
Er, ub on digital display
or
Left Decimal Point blinking on display one second on/one
second off
• This code indicates that the washer did not reach the maxi-
mum intended speed in the final spin.
• This could be due to an unbalanced load, excessive suds
in the load, or too much water left in the tub due to slow
draining.
• Be sure to use proper load sizes that are evenly distributed
in the wash basket.
• Be sure to use high efficiency (HE) detergent.
• Open the door or press the Power/Cancel keypad to clear
this code.
PF on digital display
• This code will be displayed if the control was in Delay Start
Mode when a power failure occurred.
• The delayed start will be canceled.
• Press the Power/Cancel Pad to clear the code.
Er, SL on digital display
• This code will be displayed after a cycle for one minute, or
until the Power/Cancel keypad is pressed, and indicates
an oversudsing condition.
• Laundry load may be oversudsing. Make sure you are us-
ing low sudsing, high efficiency (HE) detergent. If using
non-HE detergent, use only 1/2 of the detergent manufac-
turer's recommended amount.
• Laundry load may be overloaded. Make sure you are using
proper load sizes.
Sr, cycle time remaining on digital display
• The control has detected an oversudsing condition and is
running a special routine to remove the excess suds.
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
36 Part No. 808187ENR1
Loading ...