Loading ...
Loading ...
Loading ...
WARNING:
Alwayswearsafetygogglesorsafetyglasseswith
sideshieldswhenoperatingtools.Failuretodoso
couldresultinobjectsbeingthrownintoyoureyes,
resultingin possible serious injury
WARNING:
Do not allow familiarity with your drill-driver to make
you careless Remember that a careless fraction of a
second is sufficient to inflict severe injury
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems_
Therefore, you should charge it until light on front of
charger changes from red to green.
Note: Batteries will not reach full charge the first time
they are charged Mow several cycles (drilling
followed by recharging) for them to become fully
charged.
TO CHARGE
m Charge battery pack only with the charger
provided.
[] Make sure power supply is normal house
voltage, t20 volts, 60 Hz, AC only.
[] Connect charger to power supply.
[] Place battery pack in charger aligning raised rib in
charger with groove in battery pack.
[] Press down on battery pack to be sure contacts on
battery pack engage properly with charger
contacts.
[] Red light should turn on. Red light indicates fast
charging mode.
if red light is flashing, this indicates battery pack is
deeply discharged or hot.
If battery pack is hot, red light should become
steady after battery pack has cooled down
If battery pack is deeply discharged, red light should
become steady after voltage has increased,
normally within 30 minutes.
If after one hour red light is still flashing, this
indicates a defective battery pack and should be
replaced
Green light on indicates battery pack is in slow
charging mode or fully charged
Yellow light on and red light flashing indicates
defective battery pack. Return battery pack to your
nearest Sears Repair Center for checking or
replacing.
[] When your battery pack becomes fully charged, the red
lightwill turn OFF and thegreen light will turn ON
Im If you remove battery pack from charger and
reinsert it immediately (less than 5 seconds)
back in charger, the green light will come on
indicating full charge and slow charging mode
until removed from charger. If you remove
battery pack from charger and wait more than 5
seconds before reinserting it back in charger,
the charger will function normally.
[] After normal usage, 1 hour of charging time is requiredto
be fully charged_A minimum charge time of 1-1/2 hours
is required to recharge a completely discharged tool.
[] The battery pack witl become slightlywarm to the touch
while charging. This isnormal and does not indicate a
problem..
[] DO NOT place charger in an area of extreme heat
or cold It will work best at normal room
temperature,
,_ CAUTION:
Your drill-driver's battery pack contains special high
temperature batteries to help prevent battery damage
when left on charge for extended periods of time,
However, once the batteries become fully charged, we
recommend that you unplug your charger from power
supply and disconnect it from the battery pack.
= ,=H H, = ,=H=HH=='H==NI'11== H " =="N'I'
LED FUNCTION OF CHARGER
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK:
1. Red LED Lighted = Fast Charging Mode°
2. Green LED Lighted = Slow Charging Mode and Fully Charged Battery Pack.
3 Red LED Flashing = Hot or Deeply Discharged Battery Pack. Also Defective
Battery Pack After 1 Hour_
4 Yellow LED Lighted and Red LED Flashing = Defective Battery Pack.
................................ HHil_r H,,=l,,
Page 7
Loading ...
Loading ...
Loading ...