Ryobi RYRM8021-2A 80V HP Brushless 42 in. Battery Electric Cordless Zero Turn Mower with Bagger with Boost, 80V and 40V Batteries

Use and Care Manual - Page 29

For RYRM8021-2A.

PDF File Manual, 143 pages, Read Online | Download pdf file

RYRM8021-2A photo
Loading ...
Loading ...
Loading ...
29 — English
MAINTENANCE
Open the battery covers located on each side of the
mower.
While depressing the battery latch, grasp the handle and
raise the battery from the port.
To install, align the raised ribs on the battery pack with
grooves in the battery port and install the battery pack
into the mower.
Make sure the latch is securely locked into place.
Lower the battery cover and make sure it is closed securely.
Repeat the steps for additional batteries if necessary.
WARNING:
Make sure the latch on the bottom of the battery packs
snaps in place and the battery pack is fully seated and
secure in the mower’s battery port before beginning
operation. Failure to securely seat the battery packs could
cause the battery packs to fall out, resulting in serious
personal injury.
For complete charging instructions, refer to the Operator’s
Manuals for your battery packs and charger models.
STORING THE MOWER
The following steps should be taken before storing the mower
for the season.
Remove any build-up of grass and leaves on or around the
motor cover. Wipe the mower clean with a dry cloth. Do
not spray with a garden hose, water, or liquids to clean.
Plug the mower up to charge for the entire time of stor-
age.
NOTE: If it is not possible to leave the mower charger
connected during storage, charge the batteries at least
once a month during storage.
Store mower in a clean, dry place that is inaccessible to
children. Do not store near any appliance that operates
with flame such as a gas water heater, clothes dryer, or
furnace.
NOTE: Set the parking brake and do not leave the key
in the mower during storage. Place the key in a location
that is inaccessible to children.
If the mower must be stored outside, make sure it is
covered completely to protect it from the elements.
Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
PREPARING FOR USE AFTER STORAGE
The following steps should be taken before using the mower
after it has been stored:
Review maintenance chart.
Fully charge the batteries.
Check tire pressure and inflate as needed.
BATTERY
COVER
40V BATTERY
PORT
BATTERY
Fig. 31
Fig. 30
80V
BATTERY
80V
BATTERY
PORT
BATTERY
LATCH
LATCH
Briefly drive the mower and check all systems and com-
ponents to ensure they are functioning correctly.
Periodically inspect for frayed and deteriorated insulation
on wires.
Loading ...
Loading ...
Loading ...