Loading ...
Loading ...
Loading ...
Dual Radiant Surface Elements (If equipped)
The dual radiant surface element ismade up ofan innerand outer coil within the same surface
element. A variable control isused to operate the different coils. The smaller or innercoil has
a lower wattage and can be used to prepare smaller quantities of food in smaller pans. The
dual element can also combine both the innerand outer coils for a combined higher wattage.
The combined operation should be used to prepare larger quantities of food in larger pans.
Element On and Hot Surface Indicator Lights
You r range isequipped with two different surface control lights that will glow on you r range--
the Element On indicator light and a Hot Surface indicator light.
The Element On located on the control panel, will glow when any surface element isturned on. A quick glance atthis light after
cooking is an easy check to be sure all surface controls are turned off.
The Rot Surface indicator light, located on the control panel, will glow as the surface cooking area heats up and will REMAIN
ON until the glass cooktop has cooled to a MODERATE level.
To Operate Single Radiant Surface Elements
OFF
2 £
3 7
4 6
me@
Single RadiantSurfaceControl
1. Place correctly sized cookware on the radiant surface element.
2, Push in and turn the surface control knob in either direction to the desired
setting. Start most cooking operations on a higher setting and then turn to a
lower setting to finish cooking. The surface control knobs do not have to be
set exactly on a particular mark. Use the marks as a guide and adjust the
control knob as needed. Each surface element provides a constant amount of
heat at each setting. A glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is too small for the
surface heating area.
,
When cooking iscompleted, turn the surface element off before removing the
cookware. Note: the Element On indicator light will glow when one or more
elements are turned on. A quick glance at the indicatorlight(s) when cooking
isfinished isan easy check to be sure all control knobs are turned off. The Rot
Surface indicator light will continue to glow AFTER the control knob is turned
to the "Off" position and will glow until the heating surface area has cooled
sufficiently.
_lrt_m_'_j"{t_! Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may
still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top
of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire ifplaced
too close to the surface elements.
7
Loading ...
Loading ...
Loading ...