Loading ...
Loading ...
Loading ...
1. Rack mounting The Receivers
There are 2 options available for rack mounting the DW-11/DW-22 receivers: singly or
side-by-side with another DW-11/DW-22 Series receiver. A single DW-11 or dual DW-22
receiver can be rack mounted with the optional RMT-1KUD rack tray.
[ Note: Do not mount the receiver in a rack directly above an amplier or other source of high
heat – this could degrade the performance of the DW-11/DC-22. Always ensure adequate
airow and heat dissipation in any rack conguration.]
2. Powering The Receivers
Plug the AC/DC ADAPTER provided into the DC INPUT JACK (9) on the back of the
receiver. Then plug the power supply into an AC outlet.
[ Note: Any 13.5V DC regulated source with 400mA capability can also be used.]
Press the POWER SWITCH (2) once to turn on the receiver. The POWER ON LED (1)
will now light and the receiver is operational.
3. Antennas
The DW-11/ DW-22 receivers are supplied with ATTACHED ANTENNAS (10). As these
antennas are rear mounted, position them in the rack so the antennas can be adjusted
fully to obtain maximum range. Optimal antenna position is 45 degrees from the receiver
(at 90 degrees from each other). For maximum range, it is always best to maintain a line-
of-sight (no obstructions) between the receiver antennas and the transmitter at all times
whenever possible.
4. Connecting the Audio Output
The DW-11 and DW-22 receivers provide both a xed Mic level BALANCED XLR (7)
AUDIO OUTPUT and an adjustable line level UNBALANCED LINE/MIX 1/4” jack (8)
AUDIO OUTPUT. Both ¼” and XLR outputs can be used at the same time. VOLUME
CONTROL (6) is for UNBALANCED LINE/MIX 1/4” jack (8) AUDIO OUTPUT only (p 6).
5. Microphone Connection
Either the BALANCED XLR (7) or the UNBALANCED LINE/MIX OUT1/4” (8) can be used.
The BALANCED XLR (7) audio output is set at a non-adjustable microphone level, similar
to hardwired Mic levels. Adjust volume level from your amplier or mixing board. Plug an
XLR connector into the XLR output socket on the rear of the unit and plug the other end
into your amplier or mixing board. Make sure the phantom power on your mixing board
is turned off and the volume is turned down when making connections. To use the 1/4”
UNBALANCED LINE/MIX OUT(8) socket, follow the instructions for connecting (above),
except start the receiver volume at 1/2 MAX and adjust until the volume level is optimal. If
the volume control is set too high, you may overload your mixer or amp.
[ Note: As when making any connection, make sure the amplier or mixing board volume is at
the minimum level before plugging in the receiver to avoid possible sound system damage.]
5
DW-11/DW-22 RECEIVERS
RECEIVER OPERATION
Loading ...
Loading ...
Loading ...