Loading ...
Loading ...
Loading ...
5
CAUTION:
To reduce the risk of hearing loss, wear ear
protectors when using the vac for extended
hours or when using it in a noisy area. The unit
is ready for dry vacuuming.
After plug the power cord into the wall
receptacle, turn the unit “ON” by pushing the
switch position with 1 embossing straps is
the “ON” position.
ON OFF
1. The lter must always be in correct position to
reduce the risk of leaks and possible damage
to vac. Make sure that the lter is completely
covering the lter cage. Make sure there are
no gaps between the lter and the lid. It is
very important to assemble the lter to the
cage without any possible leaks or tears.
Any leaks will allow the picked up debris
to be blown out of the blowing port and back
into the surrounding environment.
DRY PICK-UP
4. To clean the cartridge lter, shake or brush off
excess dirt or rinse (from the inside of the lter)
with water, dry completely (approximately 24
hours) and re-install.
2. When using the vac to pick up ne dust,
it will be necessary to empty the dust tank and
clean or replace the lter at more frequent
intervals to maintain peak vac performance.
1. With the power head in an upside down position,
slide the cartridge lter down over the lid cage,
push the lter seals against the power head.
2. Turn the knob on lter retainer clockwise to
tighten, the lter into place.
3. To remove the lter for cleaning, turn the lter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the lter cap,
then slide the cartridge lter off the lid cage.
then grasp the step of knob tightly with ngers
to pull the cartridge lter out off the cage.
The cartridge lter can be used for wet or dry
pick-up, installation is the same for both.
INSTALLING THE CARTRIDGE FILTER
NOTICE:
A dry lter is necessary to pick up dry material. If
use the vac to pick up dust when the lter is
wet, the lter will clog quickly and be very difcult
to clean. If the lter gets wet, replace it before
continuing to do dry pickups.
NOTICE:
If the lter has been used for wet pick-up, it must
be cleaned and dried before dry pick-up.
Lock
1. Slide the cardboard collar opening rmly onto
the vacuum port deector until it stops against
the deector wall.
2. Position the bag so that it is distributed around
the inside of the tank.
3. Replace and secure the power head onto the
tank.
WET PICK-UP
INSTALLING THE DISPOSABLE FILTER
BAG
Remove all dirt and debris found in the tank.
The vacuum requires only a minimum of
conversion when going from dry to wet pick up.
Remove the dry use lter from the vacuum. A
clean cartridge lter may used for vacuuming
small amounts of liquids. For best results when
vacuuming large quantities of liquid, remove the
cartridge lter. When vacuuming liquids
containing debris, it is recommended purchas-
ing a foam lter and install over the lter cage.
The foam lter may be purchased by visiting our
website at www.dewalt.com, contacting our
customer service department, or purchasing at
the local D
EWALT distributor. When picking up
large amounts of liquid, it is recommend to
remove the cartridge lter. If the lter is not
removed, it will become saturated and misting
may appear in the exhaust.
ENGLISH
Disposable
dust bag
Loading ...
Loading ...
Loading ...