Loading ...
Bowl lift:
a) When mixing，rotate the hand wheel to raise the bowl until you feel it touch the
stop，this also makes the bowl more accessible for filling.
b) After mixing，rotate the hand wheel to lower the bowl. It is necessary to lower
the bowl to change agitators, avail to remove the bowl or agitators.
Note: When assembling an agitator the bowl must be in the down position, Slip
the agitator up on the shaft and turn until the driving pin in the shaft reaches the
L-shaped slot in the agitator shank, avoid the agitator to be fallen down in
running.
Maintenance
After use each time，an carefully the bowl agitators etc，make sure to keep the
machine clear.
Lubricate the bowl slide ways occasionally by applying a small amount of oil or
grease with the tip of linger.
Trouble shooting：
Trouble
Probable cause
Remedy
The mixing shaft don’t rotates
after switch on
Electric connectors are loose
Check he electric circuit, tighten
those loose connectors
Oil leakage
Oil seals are worn out
Replace those oil seals
The raising handle is too tight
Guide ways are corroded
Clean and oil the guide ways
The lead screw, bevel gear and
hand wheel shaft etc is dry
Oil them
Temperature rise of motor is too
high, below speed
Lack of voltage
Check the supply voltage
Over load
Less load
The working speed selected is too
high or agitator is not suitable
Select a suitable speed and
agitator
The noise of the gearbox is serious,
its temperature is too high
Lubrication is insufficient
Add or replace the oil
The agitator knocks with the bowl
The agitator or the bowl is
deformed
Repair or replace deformed part