Loading ...
Loading ...
Loading ...
11
Installation
1. Make sure the HDMI source and RS-232 serial source is powered off.
2. (Optional) Connect the 3.5 mm male-to-DB9 female adapter cable included with
the transmitter unit to the RS-232 port on the left rear of the unit, then connect
the cable to the computer that will be serially controlling the unit.
3. (Optional) Connect the IR extension cable included with the transmitter unit to the
3.5 mm jack to the right of the RS-232 serial port mentioned in step 2. Position
the cable’s infrared sensor in an area that allows a direct line of sight between it
and the remote control that came with the unit.
4. Connect the first HDMI source to the port on the switch marked Source A.
5. Repeat step 4 for each additional source you are connecting.
6. Connect the IR-IN cable included with the receiver unit to the IR-IN port on the
local transmitter unit, starting with IR-IN Port A.
Note: The IR-IN unit accepts a signal from a remote control and sends it to a device controlled
on the other end of the installation. Position the IR-IN unit in an unobstructed area that can
easily accept a remote control signal.
7. Connect the IR-OUT cable included with the receiver unit to the IR-OUT port on the
local transmitter unit, starting with IR-OUT Port A.
Note: The IR-OUT unit receives the signal from the remote control on the other end of the
installation and sends it to the device being controlled. Locate the IR-OUT unit in an area close
to the remote-controlled device (e.g., Blu-ray player, TV).
8.
The four sets of IR-IN and IR-OUT ports can remotely control each source
connected to the transmitter, or monitors connected to receivers. Repeat steps 6
and 7 for each additional set of IR-IN and IR-OUT units you will be using.
Note: When using the IR remote control extension functionality, only one IR device can be
controlled from a single location. For example, a single Blu-ray player cannot be controlled from
multiple receivers in an installation; you must choose one receiver in which to control it from.
9. Connect the 3.5 mm male-to-DB9 female adapter cable included with the receiver
unit to RS-232 Port A, then connect the computer to the adapter.
10. The four RS-232 ports allow connection of an RS-232 device for each receiver
unit connected to the transmitter. Repeat step 9 for each of the remaining RS-232
ports you will be using.
11.
Connect the external power supply to the transmitter unit and plug it into a Tripp Lite
Surge Protector, Uninterruptible Power Supply (UPS) or Power Distribution Unit (PDU).
12. Connect the RJ45 port marked Output 1 on the transmitter unit to the RJ45 Input
port on a receiver unit using Cat5e/6/6a cable.
13. Connect the HDMI monitor to the HDMI Output port on the receiver unit.
18-11-133-933418-EN.indd 11 11/15/2018 10:35:35 AM
Loading ...
Loading ...
Loading ...