Loading ...
Loading ...
Loading ...
Installation instructions en
19
4.
Unscrew the two lower screws on the back of the
appliance.
5.
Use the two screws to tighten the two metal retain-
ers on the back of the appliance.
‒ Ensure that the metal retainers are aligned ex-
actly with the edge of the appliance.
6.
Slide the appliance into the fitted unit and check
whether the tilt protection engages.
7.
If required, correct the position of the bracket with
the elongated hole.
8.
Finally, screw the brackets to the fitted unit.
9.
Insert the power cable fully into the appliance.
10.
Push the appliance into the fitted unit.
‒ Do not pinch the power cable.
11.
Remove the adhesive strip from the appliance front.
12.
Open the appliance carefully and check whether the
tilt protection is working.
Installing the appliance
WARNING‒Risk of injury!
When the door is opened, the appliance may tip over.
▶ In the case of installation without an intermediate
floor, weigh down the appliance with a suitable
weight before opening.
1.
Insert the power cable fully into the appliance.
2.
Push the appliance all the way into the fitted unit.
‒ Do not pinch the power cable.
3.
Centre the appliance.
4.
Remove the adhesive strip from the appliance front.
5.
Open the appliance.
6.
Screw the appliance to the fitted unit.
7.
Insert the power cable into a protective contact
socket.
The power cable must not touch the rear and base
of the appliance after installation.
Loading ...
Loading ...
Loading ...