Loading ...
Loading ...
Loading ...
35
BEFORE YOU CALL
Oven control panel sounds an
audible alarm and displays an
Error code.
Oven control has detected a fault or error condition. Turn either oven mode or tempera-
ture selector to the OFF position to clear the error code. Try Bake or Broil function. If
the Error code error repeats, turn OFF power to appliance, wait 5 minutes and then
repower appliance. Set clock with correct time of day. Try Bake or Broil function again.
If fault recurs, turn oven mode and temperature selectors OFF and call 1-800-4-MY-
HOME® for assistance.
Soil not completely removed after
Clean
Clean was interrupted. Review instructions in Clean section.
Excessive spills on oven bottom. Clean before starting Clean.
Failure to clean soil from the oven frame, the door liner outside the oven door gasket
and the small area at the front center of the oven bottom. These areas are not in the
self-cleaning area, but get hot enough to burn on residue. Clean these areas before
starting the clean cycle. Burned-on residue can be cleaned with a stiff nylon brush and
water or a nylon scrubber. Be careful not to damage the oven gasket.
Convection fan does not rotate. Oven door is open. Convection fan will turn off if oven door is opened when Convection
is active. Close oven door.
The convection fan will turn on after the oven has been heating for 6 minutes, and
remain on during the cooking process.
Clean does not work. Oven control not set properly. Review instructions in Clean section.
Surface burners do not ignite. Surface control knob was not completely turned to Lite. Push in and turn the surface
control knob to Lite until burner ignites and then turn control knob to desired flame size.
Burner ports are clogged. With the burner OFF, use a small-gauge wire or needle to
burner head slots and ignition ports.
Range power cord is disconnected from outlet (electric ignition models only). Be sure
power cord is securely plugged into the power outlet. Electrical power outage. Burners
may be lit manually. See
“Operating the gas surface controls” on page page 9.
Surface burner flame uneven or
only part way around the burner
cap.
Burner slots or ports are clogged. With the surface burner OFF, clean ports with a small
gauge wire or needle.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate
until flame is full.
Burner caps are not seated properly. Check that all burner caps are level and seated
correctly on burner heads.
Surface burner flame is too high. Surface control knob is set too high. Adjust to lower flame setting.
Burner caps are not seated properly. Check that all surface burner caps are level and
seated correctly on surface burner heads.
Incorrect L.P. conversion. Refer to L.P. conversion kit instructions to correct.
Loading ...