Loading ...
Loading ...
Loading ...
W415-2984 / B / 04.26.22
EN
18
fi nishing
5.3 crystal media / fi reglass media installation
5.2 glass removal / installation
!
WARNING
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A. Remove the front surround (see “front surround removal / installation” section).
B. Remove the four screws holding the glass retainer brackets in place, then remove the brackets and set
them aside (Fig. 5-6).
C. Remove the glass and place it face-down on a soft,non-abrasive surface (Fig. 5-7).
D. Reverse these steps to install the glass.
Fig. 5-6
Fig. 5-7
NEFL50HF-BT-LOWC
Illustrated
NEFL50HF-BT-LOWC
Illustrated
The front surround and glass must be removed and the appliance must be mounted in its fi nal location before
crystal media/fi reglass media is installed (see “front surround removal / installation” section).
A. Clean crystal media/fi reglass media with mild dish soap, drain,
rinse thoroughly, and dry before placing into the tray.
B. Carefully place crystals/fi reglass media into the bottom tray on the
front of the appliance as illustrated. Apply an even layer from side to
side.
C. Resecure the glass (see “glass removal / installation” section).
D. Resecure the front surround.
CRYSTAL MEDIA
FIREGLASS MEDIA
Loading ...
Loading ...
Loading ...