Loading ...
Loading ...
Loading ...
4
SETUP
MOVING THE HEATER
Turn off the heater.
Allow it to cool for ten (10) minutes.
Unplug heater and move. This heater is equipped with a Cool Touch Handle for your convenience.
Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9 m) away from
any wall or combustible material. DO NOT use on an unstable surface such as bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE A TRIPPING HAZARD.
For best result, place heater on the floor to create warming room convection and allow heater to run for 510
minutes to reach maximum heat output.
ABOUT CERAMIC TECHNOLOGY
ASSEMBLY
Ceramic heaters generate heat by passing electricity through heating wires embedded in ceramic plates.
This type of heating technology provides fast, even heating.
The Thermawave™ 6 Heater was designed for maximum heat output.
This heater requires simple, no tool assembly.
Unpack Main Body and Mounting Base (Fig. 1).
Place Mounting Base on a firm surface. Place ThermaWave
TM
6 Heater Main Body on Mounting
Base so Mounting Tabs are aligned with Base Slots. Press Main Body onto the Base until Tabs snaps secure
into the Slots (Fig. 2).
Fig. 1 Fig. 2
Loading ...
Loading ...
Loading ...