Loading ...
Transportation and Placement
△When transporting the chest freezer from one place to another, the inclination of
the cabinet should not exceed 45 degrees, for prevention against compressor or
system damage.
△Before use, remove all the packing material. The back side of the cabinet should
be more than 20cm away from the wall, both flank sides more than 20cm.
△The freezer should be put in well-ventilated, dry place. Don’t use it under direct
sunshine. The freezer should be kept away from water sink, heat source and any
volatile, corrosive material.
Power source and test-running
△Specified capacity of the wire is 7A. Section squares of the wire is 0.82mm2.
Single line or compound lines are all allowed. The fuse of 2.5A specified
electric current should be installed.(Power cord should be replaced with the
same of 7A and 0.82mm2, when it is damaged).
△Single-phase power supply, 60Hz, voltage range 98~132V. If the voltage is
unstable, please install a voltage stabilizer with capacity above 1000W.
△Avoid turning on and off the power too frequently. If the power is turned off, wait
an interval of 5 minutes before turning it on again.
△When the freezer will be out of use for a long time, disconnect the power first,
then clean it. Please examine the circuit whether it is excellent before reuse.
Operation of the Temperature control knob
△The temperature in the cabinet can be controlled with the temperature control
knob.
△The knob should be kept upright normally to adjust the temperature. FREEZING
MAX is the strongest cooling position and is suitable for fast freezing. Do not
keep the knob at this point for long.
Loading ...
Loading ...
Loading ...