Loading ...
Loading ...
Loading ...
21
Cleaning start
Maintenance
When scale has adhered
Clean with Citric Acid
once every two or
three months
1 Make sure that the mesh filter is attached to the container.
2 Put citric acid in the inner container.
●
Amount of citric acid to be used at one time:
80 g (two packages) or seven level tablespoons.
The citric acid is available from an authorized dealer. (Model No: SAN-80N)
* Follow the directions for cleaning printed on the citric acid package.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
3 Add water to the maximum water level mark, and
mix the citric acid and water well. Close the lid.
Citric acid
4 Connect the plug immediately after stirring and press the key
more than 3 seconds.
Indications will note
when cleaning ends.
Cleaning time (approx.)
NC-EH40P: 50 Min.
NC-EH30P: 42 Min.
NC-EH22P: 35 Min.
5 Dispense some water, then unplug, remove the lid and throw away the hot water via
the “DRAIN” mark.
6 Refill with water and boil it to remove the smell of the citric acid or lemons.
Then throw the hot water away in the same way as in step 5.
●
To remove any discoloration from the area above the maximum water level, rub the inside lightly
with a wet sponge.
●
If the discoloration cannot be removed by rubbing, clean the inner container several times using
citric acid or lemons.
Cautions
●
Use only our citric acid to clean this thermo pot.
●
Do not fill with water above maximum water level.
●
Fill the container only with tap water (do not fill with hot water). Hot water may spout out causing burns.
End of cleaning
Lit Flashing
Operating NC-EH40_EN.indd 21 11/7/07 3:57:56 PM
Loading ...
Loading ...
Loading ...