HCE1010WHT Operation and Service Manual

Loading ...

HCE1010A/W, HME1010A/W, HCE1410A/W, HME1410A/W 5

Specications

Electrical

Each ice machine requires its own separate circuit with electrical disconnect within 10 ft (6m).

Equipment ground required.

Standard electrical:

§ HCE1010: 230/50/1 (6 ft (2m) cord)

§ HME1410: 230/50/1 (6 ft (2m) cord)

§ Amperage: 1010A/W - 11A,

1410A/W - 14A

Plumbing

WARNING

This equipment to be installed with adequate backow protection to comply with applicable federal, state,

and local codes.

§ 3/8" OD push-in water inlet (connection inside machine) - 3/8" OD tubing required

§ 3/4" MPT drain

§ 1/4" FPT condenser inlet (water-cooled condenser only)

§ 1/4" FPT condenser drain (water-cooled condenser only)

Notes:

§ Water shut-off recommended within 10 feet (3m).

§ Water supply must have particle ltration. Follett recommends the lter system that has integral scale inhibitors.

(Follett item# 00130286).

§ Follett does not recommend the use of water softeners or bowl scale inhibitors.

Flush drain plumbing

§ 3/4" MPT ush drain connection at the rear of the machine.

§ Drain must slope 1/4" inch per foot (6 mm per 30.4 cm).

§ Drain line should not be shared with any other piece of equipment.

§ Drain line cannot be reduced to a size smaller than 1 inch.

§ Drain should be piped without a vent.

3/4" barb x 3/4" FPT

1" Stand pipe/Drain

2 ft. x 1" OD

silicone tubing

Minimum 8"

radius

3/4" MPT x 1" slip

1" PVC Drain

2 ft. x 1" OD

silicone tubing

3/4" MPT x 1" slip

3/4" barb x 3/4" FPT

1/4" per foot

(6,4 mm per 0,3 m)

Loading ...

Follett HCE1010WHT 30" Horizon Elite Series Water Condenser Ice Machine with 1061 lbs. Daily Ice Production, Chewblet Ice, and Agion Silver-Based Antimicrobial in Stainless Steel