Loading ...
Loading ...
Loading ...
Page 9
OPERATION
USING THE ROLLER GUIDE
For cutting circles between 4-5/8" and
8-11/16" in radius.
■ Fig. 11:
NOTE:
• Circles between 6- 3/4" and 7- 5/16" in
radius cannot be cut using this guide (because
center hole (4) is blocked).
• Align the center hole in the straight guide
with the center of the circle to be cut. Drive a
nail less than 1/4" in diameter into the center
hole to secure the straight guide. Pivot the tool
around the nail in clockwise direction.
■ Fig. 12:
Fig.12
Fig.13
■ (Fig. 13)The trimmer guide allows for
trimming the curved side like veneers for
furniture by moving the guide roller along the
side of the workpiece.
1. Loosen the clamp screw, then install the
trimmer guide on the trimmer base, and
then tighten the clamp screw.
2. Loosen the clamp screw and adjust the
distance between the trimmer bit and the
trimmer guide by turning the adjusting screw
(1mm per turn). At the desired distance,
tighten the clamp screw to secure the trimmer
guide.
■Fig.14: 1. Adjusting screw
2. Clamp screw
3. Move the tool with the guide roller riding
the side of the workpiece.
1
2
Fig.14
1
2
3
1. Nail
2. Center hole
3. Straight guide
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
Fig.11
1
2
3
4
5
Loading ...
Loading ...
Loading ...