Loading ...
Loading ...
Loading ...
4 BISSELL.com
Using the Vacuum
For additional support videos and information, visit support.BISSELL.com.
1. Gently pull the cord out and
stop at the yellow mark on the
cord. Do not pull past the red
mark. Plug into an outlet.
2. Press the red power button
with your foot to turn the
vacuum ON and OFF.
3. Press the recline pedal and
pull handle back towards you.
4. Turn the dial on the foot
to the desired setting. If the
dial is difficult to turn, tilt the
vacuum back slightly to take
the weight off the foot while
turning.
Tip: For best performance,
adjust to the lowest practical
setting. If your vacuum is
difficult to push, adjust to the
next higher setting.
5. Hold onto the plug and
press the automatic cord
rewind button until it’s fully
retracted. If the cord doesn’t
fully retract on the first try,
pull a little bit of cord out and
press the rewind button again.
WARNING To reduce the risk of injury from moving parts while the vacuum is turned ON, always move the
vacuum via the rolling wheels by using the upper handle at the back of the vacuum. Do not carry the vacuum while it is running.
Always place vacuum on floor with handle in upright position when using tools.
NOTE: Rotating floor brush continues to rotate while tools are in use. Never place fingers under the vacuum when it is running.
Never place Powerfoot on furniture or uneven surfaces.
NOTE: Certain carpets and low humidity conditions may generate small static discharges. Static discharges are entirely harmless
and are not associated in any way with the main power supply.
CONTINUED ON NEXT PAGE
Loading ...
Loading ...
Loading ...