Loading ...
Loading ...
Loading ...
9
-
Check if the water tank contains enough fresh
drinking water. Switch on machine. Power
button starts blinking red while machine is
heating up for approximately 40 seconds.
Afterwards power button lights steady green.
Machine is ready to use.
Adjust drip tray position. Place cup with
correct cup size on drip tray. See “3. BEVERAGE
EXAMPLES“ or package.
Open locking handle. Pull out capsule holder.
Make sure rinsing tool is not inside. Insert
capsule in capsule holder. Insert it back into
machine. Close locking handle.
Use selection lever to illuminate bars in
accordance with the number of bars shown
on capsule, or set bar display to your own
taste. You can select your desired cup size up
to 12 FL OZ. Wait around 1.5 min if you want to
prepare a second 10 or 12 FL OZ. cup.
Push selection lever to the “HOT” or “COLD”
position as recommended on capsule packs.
Beverage preparation starts. Wait until the
lever moves to the “STOP” position. Extraction
stops. Extraction can be stopped manually by
moving the lever back to the “STOP” position.
After finishing preparation the power button
blinks red for about 5 seconds. During that
time do not open locking handle!
After extraction is finished remove cup from
drip tray.
Open locking handle. Pull out capsule holder.
Remove used capsule. Put used capsule in
capsule bin.
Rinse capsule holder with fresh drinking water
from both sides. Dry capsule holder. Insert it
back into machine. Enjoy your beverage!
8
7
6
5
4
EN
2
1
6. PREPARING A BEVERAGE
6.1
ONE CAPSULE (E.G. LUNGO)
3
9
Loading ...
Loading ...
Loading ...