Loading ...
Loading ...
Loading ...
en Faults and what to do about them
34
Drain hose at the siphon is
blocked
1. Switch off the appliance. Disconnect
the mains plug.
2. Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3. Clean the drain hose and siphon
connecting piece.
4. Reattach the drain hose and secure
the connection using the hose
clamp.
Filter in the water supply is
blocked
:Warning
Risk of electric shock!
The Aqua-Stop contains an electric
valve. There is a risk of electric shock if
you immerse the Aqua-Stop safety valve
in water. Do not immerse the safety
valve in water.
First, reduce the water pressure in the
supply hose:
1. Turn off the tap.
2. Select any programme (except
Rinse/Spin/Drain/Empty).
3. Press the Start Reload A button.
Allow the programme to run for
approximately 40 seconds.
4. Turn the programme selector to the
off position. Disconnect the mains
plug.
5. Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.
6. For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
7. Insert the filter, connect the hose and
check for leaks.
3 Faults and what to do
about them
Faults and what to do about them
Emergency release
e.g. in the event of a power outage
Note: The programme will continue
running when the power supply has
been restored.
:Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
Loading ...
Loading ...
Loading ...