Loading ...
Loading ...
Loading ...
5
The hotplates
â Hotplates with bridge heating element
Two individual hotplates can be interconnected with a bridge
heating element to create one large extended cooking zone
Under normal operation, these hotplates both work as normal
single-circuit and dual-circuit hotplates.
To activate the bridge heating element: the single-circuit
hotplate must be switched off.
1. Switch on the dual-circuit hotplate.
2. Touch the ð symbol. The outer filament circuit on the dual-
circuit hotplate is activated. The indicator light comes on.
3. Touch the ð symbol again. The extended cooking zone is
activated. The indicator light comes on.
To deactivate the extended cooking zone: touch the
ð symbol
again. The indicator light goes out. The extended cooking zone
is deactivated.
You can also change the heat setting using the control panels
for the two hotplates.
Residual heat indicator
The hob has a two-stage residual heat indicator for each
hotplate.
If
• appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to
œ. The display remains lit until the hotplate has
cooled sufficiently.
Setting the hob
This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: touch the
# symbol. A signal sounds. The
indicator above the main switch and the
$ hotplate indicator
light up. The hob is ready for use.
To switch off: touch the
# symbol until the display above the
main switch and the hotplate indicators
$ go out. All hotplates
are switched off. The residual heat indicator remains on until
the hotplates have cooled down sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 15 seconds.
Setting a hotplate
Set the required heat setting in the settings range.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is marked in the control panel with the
Û symbol.
Set the heat setting
1. Touch the $ symbol to select the hotplate.
‹.‹ and the $ symbol for hotplate selection light up brightly
in the heat setting display.
2. Set the desired heat setting on the settings range.
Note: Hotplate temperature is regulated by the heat switching
on and off. The heat may also switch on and off at the highest
setting.
To change the heat setting:
Select the hotplate and set the desired ongoing cooking setting
in the settings range.
To switch off the hotplate:
Select the hotplate and set to 0 in the settings range.
Hotplate Activating and deactivating
$
Single-circuit hotplate
ð
Dual-circuit hotplate
Select the hotplate and touch the
ð activation symbol
ò
Tri-circuit hotplate
Select the hotplate, touch the
ð activation symbol; the 2nd filament circuit is activated
Touch the
ð activation symbol again; the 3rd filament circuit is activated
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again.
Loading ...
Loading ...
Loading ...