Loading ...
Loading ...
Loading ...
General Care & Cleaning
Cooktop Cleaning & Maintenance (cont'd)
Do not use the foJJowing on the ceramic glass cooktop:
=Do not use abrasive cleaners and scouring pads, such as metal and some
nyJon pads. They may scratch the cooktop, making itmore difficult to cJean.
• Do not use harsh cleaners, such as chJorine bleach, ammonia or oven
cJeaners, as they may etch or discoJor the cooktop.
Do not use dirty sponges, cJoths or paper towels, as they can JeavesoiJ or
Jint on the cooktop which can burn and cause discoJoration.
Care & Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Please refer to the table provided at the beginning of the Care & CJeaning section in this
Use & Care Manual.
To Remove and Replace Oven Door
Fig. 1
Removing and Replacing the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat with
the inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor- See Fig. 1).
2. Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)
3. Insert the 2 screws intothe door hinge holes located on the side of the hinge arm,
one into each hinge (See B Fig. 2).
4. Close oven door until the door stops, (Do not force the door to close any further).
The placement of these screws should keep door open in about a 45 degree
position.
5. Grasp oven door firmlyon both sides and slide door up and off hinges at the same
angle. (See Fig. 3)
6. To clean oven door, follow the instructionsinthe General Care & Cleaning table.
or
a Nail
Fig. 2
about 45
Hinge
Fig. 3
To Replace Oven Door:
1. Besurethehingearmsremainatthe45degreeangleposition. Besurethescrews
are still locking the hinge arms from moving. If the screws fall out of the hinge
holes, the hinge(s) may snap back against the oven frame and could pinch fingers
or chip the porcelain finish on the oven front frame.
2. Hold door at the sides near the top while resting the lower front of door on your
knee. Insert the door channels at the bottom of door over the door hinges, (See
Fig. 3).
3. Allow the door to slide down intothe door hinges evenly at the same 45 degree
angle. The hinge arms should be inserted intothe bottom corners as far as they
can go.
4. Open door completely (horizontal with floor) and remove both screws from holes
in door hinges.
5. Reinstall the 2 screws intothe door liner (See C Fig. 2).
6. If the door is not inalignment with the oven frame, remove door and repeat the
above steps.
14
Loading ...
Loading ...
Loading ...