Loading ...
Loading ...
Loading ...
General Cleaning
Cleaning Various Parts of Your appliance
Before cleaning any part of the appliance, be sure all controls are turned OFF and the appliance is COOL. REMOVE SPILLOVERS
AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS WILL REDUCE THE NUMBER OF MAJOR CLEANINGS LATER
Surfaces How to Clean
Aluminum (Trim Pieces) Use hot, soapy water and a cloth. Dry with a clean cloth. Do not scour or use all-purpose cleaners,
ammonia, powdered cleaners or commercial oven cleaner. Theycan scratch and discolor aluminum.
Glass, Painted and Plastic Body For genera/c/eaning, use hot, soapy water and a cloth. For more difficu/t softs and built-up grease,
Parts and Decorative Trim apply aliquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinsewith adamp
cloth and dry. DO NOT use abrasive cleaners on any of these materials; they can scratch.
Control Panel
(Models with Control Knobs)
Control Panel
(Models with tactile touch-
Membrane)
Porcelain Enamel
Broiler Pan and
models), Door Liner
Stainless Steel, Chrome
Decorative Trim
Oven Racks
Grid (some
Oven Door
Before c/eaning the contro/pane/, turn all controls to OFFand remove the control knobs. To remove,
pull each knob straight off the shaft. Clean using hot, soapy water and a cloth. Besure to squeeze
excesswatre from the cloth before wiping the panle; especially when wiping around the controls.
Excesswater in or around the controls may cause damage to the appliance. To replace knobs after
cleaning, line up the flat sides of both the knob and the shaft; then push the knob into place.
Before cleaning the contro/pane/, turn all controls to OFF. Lightly spray the control panel with a
liquid cleaner. Wipe with asoft cloth or paper towel. DO NOT useabrasive cleaners or scouring pads.
These can permanently damage the control panel surface.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution of
clear water and ammonia. If necessary, cover difficult spots with an ammonia-soaked paper towel
for 30 to 40 minutes. Rinse with clean water and a damp cloth, and then scrub with a soap-filled
scouring pad. Rinse and wipe dry with a clean cloth. Remove all cleaners or the porcelain may
become damaged during future heating.
Clean with hot, soapy water and a dishcloth. Rinse with clean water and a cloth. Cover stubborn
spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse. Cleaners made especially
for stainless steel are recommended. Besure to rinse the cleaners asbluish stains may occur during
heating and cannot be removed.
Oven racks may be removed or left in the oven during the self-clean cycle for cleaning. If removed,
clean by using amild, abrasive cleaner following manufacturer's instructions. Rinsewith clean water
and dry.
If the racks are cleaned by running them through the self-clean cycle, their color will turn slightly
blue and the finish will be dull. After the self-clean cycle iscompleted and the oven has cooled, rub
the sides of the racks with wax paper or cloth containing a small amount of baby oil or salad oil.
This will make the racks glide easier.
The door may be removed to facilitate cleaning. To remove oven door, see instructions. To clean
oven door, wash with hot, soapy water and a clean cloth. DO NOT immerse the door in water or
clean the oven door gasket. The oven door gasket isessential for a good seal. Care should be taken
not to rub, damage or remove the gasket.
10
Loading ...
Loading ...
Loading ...