Loading ...
Loading ...
Loading ...
11
Digital Gauge
The digital gauge on the air compressor is multifunctional.
It serves as a pressure gauge, monitors the amount of
pressure being applied to the item being inated.
To switch from PSI, BAR or KPA.
1. With gauge ON, press the power button to select the
desired measuring unit (Fig. 9).
To set pressure gauge for automatic shut o:
1. With gauge ON, press and hold down [ + ] or [ – ] buttons
to select desired shuto pressure (Fig. 10).
NOTE: Numbers will ash while setting pressure.
Holding buttons down will make the pressure number
increase faster.
2. When desired setting has been selected, begin inating.
Air compressor will shut o once setting is reached.
LED Light (Fig. 11)
The air compressor is equipped with a LED light above the
trigger switch to provide additional lighting for operation in
low light conditions. The LED light will turn on when the power
button [
] is pressed and will stay on for 60 seconds.
Starting + Stopping
1. Slide the battery into the battery compartment until it
clicks to lock it into position (Fig. 12).
2. To turn the air compressor ON, press the power button
[
] below the LCD display (Fig. 9).
NOTE: The digital gauge will automatically shut o when
not in use for 60 seconds or more.
3. With gauge ON, select the desired shuto pressure by
pressing [ + ] or [ – ] buttons (Fig. 10). Once it is set,
wait a few seconds until the current tire pressure displays.
NOTE: Always check and follow the manufacturer’s
recommended pressure, usually located on the door jamb
of your vehicle.
NOTE: Should the pump fail to reach the desired pressure
setting within 15 minutes, the pump will automatically shut o.
4. Place air chuck over valve stem and press down,
readout will appear on gauge (Fig. 10).
PSI
BAR
KPA
Fig. 9
Air pressure
measurement
units
Power button
PSI
BAR
KPA
0.0
Fig. 10
Air pressure
(+) Button (–) Button
Fig. 11
LED light
Fig. 12
Battery
Battery
compartment
Loading ...
Loading ...
Loading ...