Loading ...
Loading ...
Loading ...
Setting Warmer Drawer Controls
Removing and Replacing Warmer Drawer
Warmer (Warm & Ready TM) Drawer Indicator Light
The indicator light is located above the warmer drawer thermostat control. It turns on when the control is set, and stays on until
the control isturned off. The warmer drawer is inoperable du ring the self-clean cycle. The indicator light will not come onduring
the self-clean cycle.
R_ht Glide
[]
Push down with finger
Figure 1
To Remove and Replace Warmer (Warm & Ready TM) Drawer
To Remove Warmer Drawer:
1. _Ir_['*!['_lTj_/_l Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (see figure 1).
5. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready TM) Drawer:
1. Pull the bearing glides to the front of the chassis glide (see figure 2).
2. Align the glide on each side of the drawer with the glide slots on the range. _
3. Push the drawer into the range until levers"click" (approximately 2"). Pull the _,_
drawer open again to seat bearing glides into position. If you do not hear the <,,_
levers"click'orthebearingglidesdonotfeelseatedremovethedrawer _i_'?
and repeat steps 1thru 3.This willminimize possible damage tothe bearing '_'_
glides.
NOTE: The Warmer Drawer will NOT operate while in the Self:Clean and "Oven
Lockout" modes
ngGlide
Figure 2
! _l+i_f,'l,t _II_[1"11
- ' Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
15
Loading ...
Loading ...
Loading ...