Loading ...
Loading ...
Loading ...
- 11 -
sponge to achieve mechanical cleaning.
3) The filter will now be rinsed. Once clean water can be seen through the
transparent spiral stepped hose adapter at the cleaning connection, turn
anti-clockwise until it clicks into the "filter" position.
4) The filter is now operating again. Check the water flow into the pond.
5)
REPLACEMENT OF THE FILTER SPONGES
If the water flow is too small due to dirty filter sponges, and can not be
improved by cleaning the handle. The filter sponges must be washed or
replaced.
Please do not use any chemical cleaning agents so as not to kill off the
microorganisms in the filter sponges.
1. Disconnect the mains plug of the filter.
2. Switch off the pump and ensure that it cannot be switched on
unintentionally.Remove all hoses by unscrewing the union nuts.
3. Remove the protective buckle, then open the clamp.
4. Lift off the lid with the filter sponge assembly. Place the lid upside down
on another clean surface. The filter sponges are lying with the filter plate
facing up.
5. Remove the diversion pipe anti-clockwise, and remove the screws on
the gear and the separate plate.
6. Remove the filter sponges to replace or clean them.
7. Pull off the filter sponges part and clean them under flowing water. Give
the filter sponges a good squeeze.
8. Clean the container, filter sponges, O-ring and the edge of the container
by spraying them with a water hose.
9. Put the sponge part as follow, put it on a separate plate, fix the
leanness gear set, and fasten the diversion pipe.
10. Place the O-ring onto the upper edge of the container(To easily fit, you
should make it wet). Press down on the lid.
11. Put the clamp in the right place, pull on the pull tab, and finally, push
Loading ...
Loading ...
Loading ...