Loading ...
Loading ...
Loading ...
ENGLISH
8
Use BLACK+DECKER replacement spool Model No. AF-100,
and replacement cap RC-100.
Reload nylon line (either bulk or prewound replacement
spool) as shown in thismanual.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND
NYLON LINE. Do not use serrated or heavier gauge line,
as they will overload the motor and cause overheating.
This line is available at your local dealer or authorized
servicecenter.
• Other replacement parts (guards, spool caps, etc.) are
available through BLACK+DECKER service centers. To
find your local service location call: 1-800-544-6986 or
visit www.blackanddecker.com.
Replacing the Spool (Fig. M, N, O, P)
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.
• Unplugtrimmer.
• Depress the tabs
15
and remove the spool cap
25
from the spool housing
16
in the trimmer head
(Fig. M).
Fig. M
16
25
15
• For best results, replace spool with BLACK+DECKER
model no. AF-100.
• Grasp empty spool with one hand and spool housing
with other hand and pull spoolout.
• If lever
17
(Fig. N) in base of housing becomes
dislodged, replace in correct position before inserting
new spool intohousing.
Fig. N
17
18
19
• Remove any dirt and grass from the spool andhousing.
• Unfasten the end of the cutting line and guide the line
into the eyelet
19
Fig. O.
Fig. O
19
• Take the new spool and push it onto the boss
18
in
the housing (Fig. N). Rotate the spool slightly until it is
seated. The line should protrude approximately 5-3/8
inches (136mm) from thehousing.
• Align the tabs on the spool cap with the slots
20
in the
housing (Fig. P).
• Push the cap onto the housing until it snaps securely
intoplace.
Fig. P
20
CAUTION: To avoid trimmer damage, if the cutting
line protrudes beyond the trimming blade, cut it off so
that it just reaches theblade.
Rewinding Spool From Bulk Line (Fig. Q, R, S)
(use only .065 in. ROUND diameter line)
Bulk line is also available for purchase from your local
retailer. NOTE: Hand wound spools from bulk line are likely
to become tangled more frequently than BLACK+DECKER
factory wound spools. For best results, factory wound spools
arerecommended.
To install bulk line, follow the steps below:
• Unplugtrimmer.
• Remove the empty spool from the trimmer as described
in “REPLACING THE SPOOL”.
• Remove any remaining cutting line from thespool.
• Make a fold at the end of the cutting line at about 3/4
inch (19mm)
21
. Feed the cutting line into one of the
line anchoring slots
22
as shown in Fig.O.
Loading ...
Loading ...
Loading ...