Loading ...
Loading ...
3
Features
Specifications
Installation
Wallmount/Under Counter Installation
Reorient the unit’s mounting ears as per the 0U Rackmount Installation above, then put four user-
supplied screws or similar mounting hardware through the unit’s mounting ears and into the
mounting surface. The user must determine the fitness of the user-supplied mounting hardware to
support the unit before mounting.
Nominal Voltage/Frequency: 100V to 240V/50 or 60Hz
Output Power Rating (amps): 15 amps for 100V to 120V or 16 amps for 208 to 240V
AC Receptacles: 4 x IEC C13 (front), 8 x IEC C13 / 2 x IEC C19 (rear)
AC Line Cord: N/A (IEC C20 inlet)
Maximum Load Rating (amps): 16 amps
Circuit Breaker(s) (Resettable): 2 x 16 amps
Dimensions (HxWxD): 1¾ × 17¼ × 3¾ in. (44 x 445 x 108 mm)
Worldwide Compatibility for Maximum Application Flexibility
The PDU12IEC accepts 16A input power over a 100-240V range, making it compatible worldwide.
The IEC C20 inlet accepts any country-specific power cord with an IEC C19 connector, and the 12
IEC C13 (four front-facing, eight rear-facing) and two rear IEC C19 outlets offer additional flexibility
when connecting multiple items of equipment. All outlets can be adapted for specific applications
with an appropriate plug adapter.
Circuit Breaker(s)
If the current draw of the equipment connected to your power strip exceeds your model’s
Maximum Load Rating (see Specifications) for longer than a few seconds, a circuit breaker will trip
to prevent any possible damage. When a circuit breaker trips, its plunger will pop up. Remove
excess equipment and allow the breaker to cool one minute before depressing its plunger to reset
the breaker.
Grounding Lug
Use this screw (located by the power strip’s receptacles) to connect your power strip to ground.
Connecting the PDU
Note: The PDU12IEC has no power cord. Instead, it has an
IEC C20 inlet receptacle. To connect the PDU12IEC to utility
power, the user must supply a detachable power cord with an
IEC C19 plug on one end and a plug appropriate for the local
utility outlets on the other.
Attach a user-supplied power cord to the PDU by
inserting the IEC C19 connector (A) of the power cord
into the cable clamp and IEC C20 power inlet (B)
located near the end of the PDU. Install the cable
clamp to the PDU chassis (C) using the provided
screws. Then install and tighten the third screw (D) as
needed to secure the power cord connection.
Connect the other end of the input power cord to a
compatible source of AC power, such as a UPS
system, PDU or utility outlet.
A C
B
D
21-03-410-933401.indb 321-03-410-933401.indb 3 4/1/2021 2:51:56 PM4/1/2021 2:51:56 PM
Loading ...
Loading ...
Loading ...