Loading ...
Loading ...
Ordering Parts & Accessories
Please go to our website
www.capresso.com to register
your product and to order any
additional parts and accessories.
Fig. 1
GoldTone Filter
Removable Filter Holder
Water Tank Lid
Fig. 2
Showerhead
Water Tank
Control Panel
Housing
Carafe
Heating Platform
Before First Use
After unpacking your coee maker clean all the loose parts with warm water and make
yourself familiar with the dierent functions. After reading these instructions, clean
the internal parts of the machine by making two carafes using only water, without any
ground coee inside the lter.
Setting the Clock
1. When you plug the coee maker into the outlet the display will ash 12:00. All
indicator lights will be o.
2. Press the HOUR or MIN button to advance the time. (Fig. 2).
3. Push and hold the HOUR button. The hours will advance. The display will show
AM and PM. When the correct hour is displayed release the button and push and
hold the MIN button to set the minutes.
Attention: You must change the clock when the time changes
(Standard Time, Daylight Savings Time).
Automatic Start Function
If you want the coee maker to start brewing at a preset time automatically, set the
automatic start function as follows:
1. Press PROG button; the display and ON/OFF indicator light will start to blink
green. (Fig. 2).
2. Set the delayed starting time by pressing HOUR and MIN button repetitively until
the desired time is displayed. Once you have reached the desired start time press
the PROG button again. The delayed start time is now set.
3. Press AUTO button so the green indicator light illuminates.
Note: You may cancel the automatic start function by pressing the AUTO
button again until the indicator light turns o. If you want to change the automatic
start time, follow the steps above to reset. When the time is due the green AUTO
indicator light will change from green to red to show that the machine has started
brewing.
Using Your Coee Maker
Coee makers produce very hot water. If you follow the sequence as described below
you will avoid possible accidents which might cause severe injuries and burns.
1. Remove carafe from machine and ll carafe with desired amount of water.
Note: Water will be absorbed during brewing process. The brewed coee will be
slightly less than markings on carafe.
2. Open the water tank lid (Fig. 1) and ll the water tank with water.
Caution: The water level should not exceed MAX level marked on the water level
indicator on the side of the machine. If you ll too much water into the water tank
the carafe may overow with hot coee.
3. Make sure the removable lter holder sits with the handle placed correctly in the
open slot. Then place the GoldTone lter into the lter holder and ensure it ts
correctly.
Note: A size #4 paper lter can also be used instead of the GoldTone lter. Do
not use a lter paper inside a GoldTone lter. If the removable lter holder is not
placed correctly, the lid will not close securely.
Caution: If the lter holder is not engaged correctly into the housing, the drip stop
in the lter holder might not open during brewing. Hot water and grinds could
overow and leak from the machine.
Drip Stop
Water Level Indicator
Plug
Coee Scoop
Loading ...
Loading ...