Loading ...
Loading ...
Loading ...
26
ENG
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of the
water used. This is intended to optimise and customise the level o f salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Open the door and switch on the appliance
2. Press the Rapid button for more than 5 seconds, when the salt indicator flashes means entering the water
softener settings. set model within 60 seconds after the appliance was switched on.
3. Press the Rapid button to select the proper set according to your local environment, the sets will change in the
following sequence:
H1->H2->H3->H4->H5->H6.
4. Without operation in 5 seconds or press the Power button to complete the setup and exit the setup mode.
1°dH=1.25
°fH=0.178mmol/l
°Clarke=1.78
The factory setting: H3
Contact your local water board for information on the hardness of your water supply.
NOTE
Please check the sectiion 3 “Loadiing The Sallt iinto The Softener compartment” of PART I: Generic Version, If your
dishwasher lacks salt.
NOTE
If your model does not have any water softener, you may skip this section.
Water Softener
The hardness of the water varies from place to place. If hard water is used in the
dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt container specifically designed to eliminate lime
and minerals from the water.
WATER HARDNESS
Water softener level
Salt
consumption
(gram/cycle)
German
°dH
French
°fH
British
°Clarke
Mmol/l
0 - 5 0 - 9 0 - 6 0 - 0.94 H1->Rapid Light bright 0
6 - 11 10 - 20 7 - 14 1.0 - 2.0 H2->90 min Light bright 9
12 - 17 21 - 30 15 - 21 2.1 - 3.0 H3->90 min, Rapid Light bright 12
18 - 22 31 - 40 22 - 28 3.1 - 4.0 H4->ECO Light bright 20
23 - 34 41 - 60 29 - 42 4.1 - 6.0 H5->ECO, Rapid Light bright 30
35 - 55 61 - 98 43 - 69 6.1 - 9.8 H6->ECO, 90 min Light bright 60
Loading ...
Loading ...
Loading ...