Loading ...
Loading ...
Loading ...
AOM9SE2 90cm Oven Installation and Operation Manual
Fitting on a power supply cable
Opening the terminal board:
Using a screwdriver, prise open the side tabs of the terminal board cover;
Pull open the cover of the terminal board
To install the cable, proceed as follows:
Remove the wire clamp screw and the three contact screws L-N and EARTH
Fasten the wires beneath the screwheads using the following color scheme;
Blue( N) Brown( L), Yellow- Green (EARTH)
Fasten the supply cable in place with the clamp and close the cover of the
terminal board.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load indicated on the data plate.
When connecting the cable directly to the mains, install an omnipolar circuit-breaker
with a minimum contact opening of 3 mm between the appliance and the mains. The
omipolar circuit breaker should be sized according to the load and should comply
with current regulations (the earth wire should not be interrupted by circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of
more than 50
o
with respect to the room temperature, anywhere along its length.
Before making the connection, check that:
The electrical safety of this appliance can only be guaranteed if the oven is
correctly and efficiently earthed; if you have any doubts call in a qualified
technician to check the system. The manufacturer declines all responsibility for
damage resulting from a system which has not been earthed.
Before plugging the appliance into the mains, check that the specifications
indicated on the date plate (on the appliance and/or packaging) correspond to
those of the electrical mains system of your home.
Check that the electrical capacity of the system and sockets will support the
maximum power of the appliance, as indicated on the data plate. If you have
any doubts, call in a qualified technician.
If the socket and appliance plug are not compatible, have the socket replaced
with a suitable model by a qualified technician. The latter, in particular, will also
have to ensure that the cross section of the socket cables are suitable for the
power absorbed by the appliance. The use of adapters, multiple sockets and/or
extensions, is not recommended. If their use cannot be avoided, remember to use
only single or multiple adapters and extensions which comply with current safety
- 11 -
Loading ...
Loading ...
Loading ...