Loading ...
Loading ...
Loading ...
Step 3: Install the faucet
Note: If there is no hole in your kitchen sink or countertop, you have to drill one (1")or use the hole for the soap
dispenser.
Installation of the filter system
Step 1: Fix the filter head and the filter
1. Paste the assistant label to finish drilling. (Note: Mount the water filter
at least 2 inches higher than the ground for easier filter change.)
2. Install the screw and reserve enough space to hang the filter.
3. Hang the filter system on the screw.
Step 2: Connect the water supply (cold water only)
1. There is an existing mark at the end of the tubing for you to confirm if
the tubing is fully inserted into the fitting.
2. Connect one end of the 1/4" PE tubing to the inlet of the filter head.
Until you reach the mark on the tubing.
3. Shut off the water supply and remove the faucet hose. (Figure 1)
4. Connect the feed water adapter and ensure that the rubber O-ring is
loaded.
• If the angle valve outlet is 3/8”, connect it to the water supply and faucet
hose directly.
• If the angle valve outlet is 1/2”, you need to remove the above two
fittings before connection. (Figure 2)
Figure 1 Figure 2
3/8" Cold water valve 1/2" Cold water valve
Mark for
full insert
1. Insert the faucet spout into the faucet body.
2. Insert the faucet stem into the hole on the countertop.
Under the sink, slip on other parts in the order shown in
the picture.
3. Firmly insert the quick-connect fitting onto the faucet
stem.
4. Connect one end of the tubing to the quick-connect
fitting of the faucet, then lock the clip. If you want to pull
out the tubing, remove the clip first.
5. Connect the other end to the outlet of the filter head.
6. Push the tubing into the fitting until you reach the mark
on the tubing.
Mounting washer
Countertop
Nut
Faucet spout
Quick-connect
fitting
Faucet body
Faucet stem
Clip
Clip
Loading ...
Loading ...
Loading ...