Loading ...
Loading ...
Loading ...
_, WARNING: Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
LOADNNG THE TOOL WNTH BRADS
See Figures 4 - 6.
[] Remove battery pack from the tool.
[] Hold tool upside down, squeeze latch, and slide base
open.
[] Place brads in the center of the channel with "T" head
sitting on the slot base. Close base while making sure
brad strip stays upright in channel.
[] Make sure that the latch is securely locked in place.
[] Reattach battery pack to tool.
BRADS
Fig. 6
SETTING DEPTH
See Figure 7.
[] Rotate the depth adjustment knob clockwise to use
more force for nailing or stapling.
[] Rotate depth adjustment knob counterclockwise to use
less force for nailing or stapling.
[] Test on a scrap piece of the same material you are
using to achieve the desired results.
NOTE: Harder materials will require more force to nail
or staple.
iNCREASE DECREASE
FORCE FORCE
Fig. 7
NANLING OR STAPLNNG
See Figure 8.
[] Hold handle firmly with magazine flat to workpiece
forming a 90° angle.
[] Press the activation foot of the nailer/stapler down
against the workpiece to disengage the safety
interlock. The activation foot must be depressed before
the switch trigger is depressed.
[] Pull switch trigger to drive brad or staple.
[] Release the switch trigger and activation foot before
driving another brad or staple.
NOTE: You must release the activation foot and switch
trigger after each brad or staple to reset the tool.
The tool will not drive another brad or staple until the
activation foot and switch trigger are released.
Fig. 8
12
Loading ...
Loading ...